ScaleRID uses state-of-the-art technology in electronic water conditioning. ScaleRID's electronic field continually fluctuates, covering a wide range of frequencies, thus treating the widest range of mineral concentrations at any rate of water flow. Other similar units on the market have a much higher price and are often of inferior quality. Permanent magnets have been shown to condition hard water, but they are only effective within a certain flow "window" and at higher and lower flows the performance drops to zero. This is the reason why permanent magnets have mixed performance results. Magnetic particles can also build up inside the pipe where the magnets are placed, eventually causing blockage or reduced water flow.
With a salt-based soft water system you must buy an expensive softener and then periodically add salt. Salt-based softeners do not always cure the limescale problem and they can make your water unsafe for people with certain health problems.
But with the ScaleRID, within the first week you will see elimination of new scale deposits, and loosening of existing scale. Soap will lather easier, your skin will feel softer and your hair will be more manageable. Spots on dishes will be reduced.
In around 2 to 4 weeks or earlier, you should definitely notice:
- The softening of scale around faucets and showerheads
- Water will feel hotter with improved performance of water heaters, washing machines and dishwashers
- The ability to reduce the amount of soap, shampoo, detergents and cleaners used
- Easier cleaning of surfaces, especially chrome fixtures, baths & sinks
Do-it-yourself installation is quick and simple - and does not require a plumber or the cutting of pipes.
1 - Locate the pipe where your water supply first enters your home and lay the Quick Connect Coil on the pipe.
2 - Mount the Control Module with the provided hooks or screws.
3 - Attach Foam Adapters (provided) and click the Quick Connect Coil over the foam.
4 - Attach wires from Quick Connect Coils power supply to Control Module and then the power supply to the electrical outlet.
You only need to periodically verify that both LED lights are on. Easy installation also means that, should you move, the ScaleRID SR-2000 is simple to disconnect and take with you.
The ideal place to install your ScaleRID is at the water inlet for the building. If this is not possible, it can also be installed at the inlet of the water heater. To install the unit, you require at least 12" of straight pipe for ScaleRID SR-2000. This can be a horizontal, vertical or diagonal pipe. The ScaleRID SR-2000 fits any standard water pipe size of 1/2", 3/4" or 1" diameter.
The ScaleRID SR-2000 comes with a full, 3-year warranty to be free of defects in material and workmanship. Visitors of the IHS Mall website save $318 with free shipping and handling to pay only $179.